I have cut a significant amount of wood on my Excalibur EX-21, which is evident from the wear on the table. Before this project, I had never seen the sawdust accumulate like this. The pile shown is less than half of the total sawdust generated. Some of the sawdust ends up on the floor, while most of it gets collected by the dust collection system under the table.
My dust collection system for most of my shop relies on a Ridgid vacuum and a separator that effectively removes all but the finest dust particles. The vacuum is equipped with a Gore CleanStream Pro HEPA filter, which captures the remaining dust. Additionally, I have a Wen air filter mounted on the ceiling that captures a significant amount of fine dust, although it still doesn't eliminate it all.
No comments:
Post a Comment