Odin's Toy Factory

I started with a cheap Taiwanese cast iron saw. It immediately became apparent that the pin end blades were not going to hack it. I installed a modification that let me use good quality pinless blades and I was on my way. I made some nice Victorian fretwork pieces with that setup. Blade changes were difficult. Oak Scrollsaw Fretwork Shelf Cut On An AMT Castiron Scrollsaw These were made in Taiwan and sold under several different brands. They also made several models. There are a lot these scroll saws still available on the used market. You can pick one up for $50 or even less. Pinless upgrades were still available last time I looked. The blade changing left a lot to be desired and the built-in blower was worthless. I replaced the blower with an old aquarium pump. It's a good idea to have a few extra blade clamps. When a blade breaks the clamps sometimes flying across the shop. As far as cut quality goes it cut very well. Glass smooth surfaces were easy to get in har

Stanley Block Plane Used to Smooth the Flat Surfaces of This Wooden Toy Car Body I don't know why I never thought of this before. Possibly, because I have been conditioned to think of planes as something you use for making furnture or trimming a stuck door. I have watched many YouTube videos about making wooden toys. I can only recall one instance where a plane was used. I saw this yesterday. Lots of toys have flat surfaces that could be planed. Some of them will require a bit of ingenuity to figure out how to hold the irregular shapes.  I can cut a pretty good line with a scroll saw. However, it's almost never perfect. This is especially true with the thicker bodies where the blade will sometimes try to follow the grain. I can cut it smooth enough that I can't see the ripples with my naked eye, but my fingers know the difference. The imperfections can be amplified when you apply paint or other finish and it really shows when you sand between coats. Better and eas

Jorgensen Clamps are the best clamps I own. Especially the Heavy Duty versions. I had a few of and was picking up a few at a time until I I found out they were moving production to China. I went to every Home Depot in my area and bought all of the Made in USA clamps I could find.  They were pretty easy to spot because they all had wood handles while the Chinese made ones had the newer style rubber coated plastic handles. When I heard the company folded I hit the stores again and bought what they had left that I thought were good enough.  These were all made in China. The fit and finish were not as good as the made in USA clamps but so far I really haven't had an issue with them. These are big heavy clamps and I don't use them for everything. Every once in awhile when you really need to squeeze something hard these will do the Job. With 1500 pounds of clamping pressure it's almost like clamping. In a vise. I still search for used ones. When I find them, for sale on eBa