Odin's Toy Factory

Label Central  Machinery Jointer For Shopsmith Model 1641 Date 1988.11   I purchased an older Shopsmith that came with two SPTs (Special Power Tools) still in their original boxes. A jigsaw and a six-inch jointer. Both were made by Central Machinery in Taiwan to fit the Shopsmith. I had no interest in the jigsaw and sold it immediately. Central  Machinery Jointer For Shopsmith Still In The Box It Was Shipped In The jointer box was beaten up pretty bad and showed signs of getting wet, but it was still covered with the thick oils that these tools are shipped from the factory.  New in the box but damaged. One end was sticking out and had some deep corrosion on it, and despite the oils, there was lots of surface rust. Removing Rust Using A Scotch-Brite Pad And A 1/4-sheet Sander I have been using steel wool and WD40 for many years to remove corrosion. In the past few years, I have switched to 3M Scotch-Brite pads. When removing rust from large flat surfaces such as this jointer, I use a Sc

Shopsmith Central Machinery Jointer In Its Original Water Damaged Box Used tools can be great bargains, but some times the best deals need some elbow grease applied to get them in usable condition. Often they have been neglected for a long time or stored and maintained improperly—simple things like keeping castiron waxed can go a long way to preventing rust and corrosion.  I recently purchased a Shopsmith for a low price. It was in a storage facility that had no way to test the powerhead. They needed the space cleaned out right away. There were two unidentified. Accessories still in their mangle shipping boxes, with the banding still on them. One of the boxes was very heavy, and I knew from the weight and size of the box that it was a jointer.  Shopsmith Central Machinery Jointer Label Made In 1987 When I got it home and opened the box, not only was it a jointer, but it was a rare 6-inch Jointer made by Central Machinery for Harbor Freight Tools. It was clear t