Odin's Toy Factory

I have done all the repairs and modifications and used the drill press for a while on several small projects. I'm going to call this a success. Replacement South Bend Chuck on MY Grizzly Drill Press The chuck worked just as I had expected. It works with bits smaller than the spec sheet indicates and is much better than the chuck that came with it. So much better than I'm considering buying a larger version for my large drill press. I got exactly what I wanted. A good drill press that would handle smaller bits. I use drill bits down to wire gauge sizes that neither my Shopsmith or larger drill press can handle. For production purposes, I didn't want to have to fool around with adapters or changing chucks. Some of the knobs were damaged, and I replaced them with these red ball knobs I found on Amazon. They came 10 to a bag, but they cost only $7.95. I had forgotten how much better I like ball knobs on a drill press. I plan to add these to some of my other tool

Bad Bob's Custom Motors - Handmade Wooden Car Bodies - Coupe & Sedan Most of the sanding was done with belt sanders. Delta Model 31-340 1x48-inch Belt Sander and my Shopsmith 6x48-inch belt sander. I consider belt sanders essential to a toy makers shop. Before sanding, I rounded over the corners with a clean, sharp 1/8-inch radius round over bit paying very close attention to grain direction to prevent as much tear out as I can. It's ok to back route when doing this because the cut is so small. You can do the round over by hand with sandpaper but the router is more consistent and faster. The rest of the sanding was done by hand using various sanding tools I have made and fingernail file scraps. Delta Model 31-340 1x48 inch belt & 8 Inch Disk Sander Shopsmith - 6x48" Belt Sander